Found a small nick in my Bedknife that's preventing it to cut in a very small 1/4 inch section. Need a replacement and didn't know which one to get and from where? Ummm cutting at 5/8 hoc right now and I have a JD 220-E
Thor865
All the way in page 8 - John Deere 220E (2013) Reel Replacement and Reconditioning
220E Maintenance sheet lists all your parts options. I used the ET17767. It is thicker and works well for the HOC we target on a green mower. Pete1313 thread has pictures comparing them both.
This chart has the HOC descriptions.
https://www.greenfarmparts.com/ (free standard shipping) or https://www.greenpartstore.com/
220E Maintenance sheet lists all your parts options. I used the ET17767. It is thicker and works well for the HOC we target on a green mower. Pete1313 thread has pictures comparing them both.
This chart has the HOC descriptions.
https://www.greenfarmparts.com/ (free standard shipping) or https://www.greenpartstore.com/
Yes, below 0.3in the knife will hit the ground/concrete.
I use a torque wrench in lb in (not lb ft!)
I use a torque wrench in lb in (not lb ft!)
No! The opposite, anit-sieze. It is all explained in the thread and the manual. Start at the middle and go out alternating sides.
As explained in the thread, you will likely need an impact wrench and use a wide/thick flat head bit.
As explained in the thread, you will likely need an impact wrench and use a wide/thick flat head bit.
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
