Lawn Care Forum banner
1 - 8 of 8 Posts

· Registered
Joined
·
68 Posts
Discussion Starter · #1 ·
Wow, 1000 miles round trip. Left Holly Springs, NC at 7pm Wed, landed at Weeks in GA Thurs am about 5am, slept a few till they opened and picked up some mowers I had bid on. I went for a JD 220E and decided to bid on some other mowers also. Eight in total. Two more JD 220a with groomers, two Toro 800, two Toro 1600, and one Jacobson.
I was glad to get back home, Thurs night about 7pm, with them. I rented a open 6x12 trailer fromu Uhaul and that worked out perfect. I towed it with my near 20yr old Dodge Ram 2500 Diesel.
After some shut eye, I removed and cleaned the carb and gas tank (and fuel filter which is under the tank). Cranked on first pull and runs smoothly at low to mid throttle, but I think some jets might be still dirty in the carb because at top speed it stumbles and surges a bit.
Everything works on the 220e and I cut my dormant Bermuda with it after raising it up some amount, about what I was cutting with my true cut. Probably about a half an inch or so, maybe less. I need to make a HOC tool before the growing season.

Next I plan to go through the other mowers and see what's what when I get some more time. Yep I was totally stoked the whole drive down and back...




 

· Super Moderator
Tifgrand—7,500 sq/ft—Baroness LM56
Joined
·
5,774 Posts
Congrats on the large haul of GM's!!! What are your plans with the rest of them?
 

· Registered
Joined
·
68 Posts
Discussion Starter · #6 ·
Thanks for the welcome here folks. I had been on best lawn for years. I learned so much from you folks there, thanks.
I had been wanting to participate in the Weeks Auction for the last couple of years but I was only now able to get in on it through the Proxibid website. I think the turf auction at Weeks has been an annual event occurring in December. I had been hoping to make it happen this year and everything worked out.
I will be selling some of what I bought as I go through it all. I really was just hoping to get a couple for myself but with the effort and travel expenses, I thought I would get what I could to fill a trailer.
 

· Registered
Joined
·
68 Posts
Discussion Starter · #8 ·
J_Nick: Thanks and that's exactly what I found about mowing pace when I cut today. And practicing those turns, while watching the axles to not cut a tire or take out the neighboring fence. Maybe it'll work it self out as I run it with good gas and a little Seafoam it as well.
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top