Lawn Care Forum banner
1 - 8 of 8 Posts

· Registered
Joined
·
147 Posts
Discussion Starter · #1 ·
Just ordered a proplugger and I'm going to use it to seed some of the bare patches in my lawn. My question is, what is a good procedure/ hole filling mix to use (soil, sand, fertilizer, etc.)? Also what dept should I use?
 

· Registered
Joined
·
147 Posts
Discussion Starter · #5 ·
I'm thinking that actually covering the seed with a mix (the elements of is part of my question) will increase the germination rate. Basic broadcast spreading does not generally lead to a great rate of germination.
 

· Registered
Joined
·
1,684 Posts
But, a proplugger pulls large tubes or dirt. 2",4",6". How will that help with seeding with a large and deep hole? I would recommend a garden weasel for smaller spots. Roll it back and forth until the dirt is all loose, drop seed, roll once more to work it into the dirt. Cover with peat moss or something to help retain moisture if you wish.

https://www.lowes.com/pd/Corona-8-5-in-Aluminum-Multipurpose-garden-hand-tool/1000373725
 

· Registered
Joined
·
2,722 Posts
The ProPlugger is a different tool that you'd use for a different function, but with similar means to an end: growing grass. If you're planning on growing plugs, I would just use a garden trowel to dig up dirt, and put seed that was grown in peat pots into the holes. I used this to put new seedlings into areas of my lawn that were bare from the reno that I did last year.

Conversely, I used the ProPlugger to transplant plugs of grass from the thicker areas that were in my yard where there wasn't much grass.

Here's some pictures of grass that was grown from peat pots and transplanted, and plugs that were transplanted. Can you tell which one was cultivated from which? Take a guess in a post, and I'll reveal the answers in a reply.







 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top