Lawn Care Forum banner
1 - 1 of 1 Posts

· Registered
185 Posts
Discussion Starter · #1 ·
I was curious if anyone has figured out a way to modify the TimeMaster 30" to cut higher than 4.25"?

My understanding is the equivalent (commercial) Exmark 30" can cut at 4.5" or 5", so I was hoping there might be a way to mod the TimeMaster to make that happen. The extra .5" to 1" in height could make a big difference in heat waves like we've been seeing here in the Northeast recently. From the research I've done, it doesn't look like Toro sells any wheel mods to make this happen.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.