Lawn Care Forum banner
1 - 16 of 16 Posts

· Registered
Joined
·
209 Posts
Discussion Starter · #1 ·
I have a small Generac pressure washer. It was bought brand new like 5 years ago, but I have not used it for about 2 years. I drained all the old gas out and filled with fresh. Wouldn't start. I removed spark plug and it's getting a spark. I remove cover and sand down the flywheel a bit, still nothing!

I go to the store and get some carb cleaner and take carburetor off and spray it with cleaner. I reassemble it all still nothing! I pout a little gas into the intake and eventually get it running, but will not stay running without spraying carb cleaner through intake.

What can I do to keep this thing running? Apparently it's a fuel delivery issue but where?
 

· Registered
Joined
·
41 Posts
I don't see where you stated that you disassembled the carb to clean it? You said you took it off and sprayed it. You need to clean the jet, the needle valve and seat etc......ethanol gas will gum up a carb every time especially if you let it sit unused.
 
G

·
Use a thin stiff metal wire piece like off a grill brush to push thru the micro thin hole on the main jet carb cleaner may not get it clean enough to blow thru...ask me how I know :)
 
1 - 16 of 16 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top