Lawn Care Forum banner
1 - 19 of 19 Posts

· Registered
Joined
·
36 Posts
Discussion Starter · #8 ·
I have noticed a little clover beginning to pop up in random patches. Patches only about the size of a basketball. I had planned to spray the entire yard to kill anything I haven't spotted yet, or prevent additional weeds. Is that not a good plan? I figured if I were to spray the entire lawn, then that would carry me into the fall.
 

· Super Moderator
Tifgrand—7,500 sq/ft—Baroness LM56
Joined
·
5,748 Posts
Gboyet93 said:
I have noticed a little clover beginning to pop up in random patches. Patches only about the size of a basketball. I had planned to spray the entire yard to kill anything I haven't spotted yet, or prevent additional weeds. Is that not a good plan? I figured if I were to spray the entire lawn, then that would carry me into the fall.
Have you applied a Pre Emergent yet? I think you will get about a 30 day residual with a broadcast Celsius app which isn't a bad idea as it should take care of the majority of the weeds and then you can reassess your course of action after a few weeks.

RandyMan said:
Just curious.What is some of the weeds in the 10 %? With just 10 % i am guessing this will be a spot treat?
The other 10% is mainly Sedges which you would need to get some Sedgehammer, Dismiss or Certainty to take care of those weeds.
 

· Registered
Joined
·
36 Posts
Discussion Starter · #10 ·
I applied a pre-emergent about 3 months ago and I have a little sulfentrazone I purchased at Walmart from February. It is only 1.6% sulfentrazone. If needed, I can grab some Sledgehammer locally. Now that you mentioned it, you are correct, about the sedges.
 

· Premium Member
Joined
·
2,329 Posts
Gboyet93 said:
I applied a pre-emergent about 3 months ago and I have a little sulfentrazone I purchased at Walmart from February. It is only 1.6% sulfentrazone. If needed, I can grab some Sledgehammer locally. Now that you mentioned it, you are correct, about the sedges.
I'd honestly buy some dismiss and call it done.

Dismiss, Celsius and some surfactant and I honestly think that lights up literally 97 percent of stuff you don't want in Bermuda.

I do caution- watch the temps and watch your spot spraying for being too heavy.
 

· Registered
Joined
·
36 Posts
Discussion Starter · #13 ·
Sounds like a plan. I have a Stihl back pack sprayer. The sprayer is calculated to the best of my ability with teejet and teejet pressure check valve. I only use the stihl sprayer to spray the yard. I figure if my equipment is always consistent, then my only variable will be the chemicals, chemical percents, etc.
 

· Registered
Joined
·
74 Posts
Gboyet93 said:
Next question??? What rate should I mix Dismiss and Celsius? Low, medium, or high? My opinion is middle rate for both??
Depends, if you're not trying to achieve any residual control with the sulfentrazone, I would run it at 1/2 the low rate. I find a product called Q4 plus to be very effective on sedges. The high rate of product puts out sulfentrazone at very small amounts like less than 1 oz/A. I frequently roll my own Q4 to save money by mixing a 3 way + 3/4 rate Quin + 1/2 low rate of sulfentrazone. It is still very effective on sedges but not a high enough rate for residual control. Anytime I run celcius, its usually at the medium rate, (or low with MSO) and it seems to do everything I need at that level.
 

· Registered
Joined
·
945 Posts
I would be mixing it to kill certain things, not mixing to simply mix. You will discolor your bermuda with Dismiss in heat even without a surfactant. Celsius alone won't do that. If you need to kill sedges use the Dismiss. If you want to kill just about everything else, use the Celsius.
 
1 - 19 of 19 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top